 |
Curve the corner with sanding tool. |
 |
I put sliced rod into the gap between the arm and the base. It's important to even the angle of arms. |
 |
Here is the close shot of the joint. For portability, I did not glue them together. As shown in the following photo. 12 arms attached to the long flat bar. I attach 6 receptacles for the JDB. |
 |
Just insert the arms into the slit and then lean the JDB panels. |
 |
Here is the close shot of the slit. The center rod is just for decoration. Both side bars actually hold the arm base. |
 |
Just leaning the JDB panel without glue. |
 |
Close up. |
 |
For painting, after spraying white primer, spray Mr. Color 316 white and then apply enamel black wash. You can see how many cotton swabs I used just for this panel. |
 |
Wash the arms as well. |
 |
Finally, paint enamel German Gray for chipping. |
 |
Almost finish |
 |
Spray Gunze's Mr. Hobby 343 Soot for jet exhaust. |
 |
See how JDB weathered. |
